Deze artikelen zijn misschien interessant voor u:
See all results
Jouw winkelwagen
(0) artikelen
FAQs
The Tech‑10 collection is Alpinestars’ flagship motocross/off‑road boot range, engineered for maximum protection, controlled flexibility, and bike feel for MX, Supercross, and enduro riding. The chassis integrates the Frontal Flex Frame, a biomechanical inner ankle brace, and the Dynamic Heel Compression Protector for impact attenuation and joint control, and is CE‑certified to EN 13634:2017.
If you’re comparing other off‑road footwear options, explore our broader MX boots collection.
All Tech‑10 variants share the same protective architecture and articulated control; they differ mainly in airflow management and outsole design for specific conditions.
| Variant | Ventilation / Climate | Outsole & Primary Use |
|---|---|---|
| Tech‑10 | Balanced ventilation for most track and off‑road conditions. | Grip‑sculptured sole with replaceable insert; optimized for motocross performance and peg feel. |
| Tech‑10 Supervented | Maximum airflow via front inlet ports, ventilated shin plate, mesh/perforated zones; ideal for hot weather. | Revised sole with extended honeycomb for peg grip and water/mud run‑off; MX in high‑heat conditions. |
| Tech‑10 Enduro | Standard ventilation. | Dedicated Enduro dual‑compound sole for traction and shift feel on technical terrain and mixed surfaces. |
Yes. Tech‑10 boots are CE‑certified to EN 13634:2017, the European standard for motorcycle footwear. This standard defines requirements and test methods specific to motorcycle boots used on‑ and off‑road, covering protective performance and construction criteria.
Fit should be secure at the heel and midfoot with enough toe room for shifting and all‑day riding. Use your foot length and the size chart to select a snug, supportive fit; MX boots typically relax slightly after a short break‑in. Adjust the buckle tension so the shin and calf are held firmly without pressure points, accounting for your preferred MX socks or braces.
After riding, rinse off mud with low‑pressure water, then use mild soap and a soft brush to remove dirt. Avoid solvents, bleach, and high‑pressure washers. Air‑dry at room temperature away from direct heat or sunlight. Periodically inspect and clean buckles/hinges and apply light silicone to moving hardware as needed. If your boot includes a removable inner bootie, take it out to dry fully before storage.
